Wednesday, September 3, 2008

Remove Watch Links

After purchasing a new watch, many people find that the watch is either too big or too small for their wrists. A jeweler will be able to remove or add links for around $10, but for those who want to save a little money or learn a new trick, this post is for you. The following directions are for the most popular watch bracelet links, the split pin bracelet. Another good source for other type of watch bracelets are available here or here.

The first step is to determine how many links you need to add or remove to your watch bracelet. This is a bit of a guessing game, but you should factor in how snug or loose you like to wear your watch.

Once again, the fun begins at the back. You will notice the small arrow indicating the direction the pin should be removed. In this case, the pin will be pushed down and out.


You will start at the top of the arrow, and push the pin down and out with either a watch pin remover (pictured below) or a thumb tack and small hammer.

A watch pin remover like the one below costs $5 to $10 and can be found at sites like this one or even on Amazon.com.

Place one side of the watch band on the remover, and align the pin to the hole and push in the direction of the arrow. With the watch pin remover, you need only screw it gently until the pin comes out. If you are removing links, you will need to take out another pin. If you are adding links, now is the time to connect the spare links often provided with your watch. NOTE: If you are removing a total of four (4) links, be sure to take two (2) from each side so the watch bracelet remains even.

Remove the pin, using your fingers, a pair of needle nosed pliers, or a pair of tweezers. Take care not to loose these small split pins. Notice how the split side of the pin is slightly larger. The larger, split side should NOT go in first when re-inserting the split pin.

When re-inserting the pin, be sure to go against the arrow. The non-split, smaller side of the pin will go in first. The split, larger side of the pin is touching the watch link remover.

Voila!
You should be ready to wear your well fitted watch now.

It would be great to get feedback on other ways of doing this without a watch link remover. Also please let me know if you have questions about removing other types of watch bracelet links. The links above may answer some questions.

4 comments:

ken said...

Thanks - your instructions were very clear.

Banting ReeF said...

Tq for the info

mahakk01 said...

Your post is very useful. My watch not fits in my hand and I want to remove watch links. I understand all the instruction in this post so that I can easily accomplish my task and use my watch. You steps are very well defined here.
vintage wedding band

♥Tifneey said...

thank you for the post! super informative and clear :)